Metrologic Instruments MS2220

INSTALLATION

CABLE INSTALLATION (INTERFACE SPECIFIC)

IBM 46XX

The following steps describe how to properly install the cables for an IBM 46xx StratosS application. The scanner/Avery scale

must then be configured to match the host’s IBM 46xx parameters. Cable installation alone does not guarantee that the

StratosS will communicate properly with the host system.

Configuration bar codes are located in the MetroSelect Configuration Guide (MLPN 00-02407x) and the

MS2xxx Stratos Series Configuration Addendum (MLPN 00-02034x).

1. Turn off the host system.

2. Plug the 10-pin RJ45 end of the IBM interface cable (MLPN 57-57212x-N-3) into the 10-pin socket labeled Scanner Host

46xx, on the bottom of the StratosS. Refer to Figure on page 23.

3. Connect the other end of the IBM cable to communication port 9 on the host device.

Before continuing verify that the IBM cable is connected to the appropriate interface socket on the scanner. An

incorrect cable connection can cause communication problems or potential damage to the scanner and/or terminal.

Manufacturers Note: Plugging the scanner into the serial port of the host device does not guarantee that scanned

information will appear at the host device. A software driver and correct configuration settings are also required for

proper communication to occur.

Steps 4 and 5 are for dual cable interfaces where the scale and the scanner connect to the host with their own separate

communication cables. Skip to step 6 for a single cable interface where the scale and scanner connect to the host with a

single cable.

4. Plug the 10-pin RJ45 end of the dual interface cable (MLPN 57-57000x-N-3) into the 10-pin socket labeled Scale RS232

to Host on the bottom of the bottom of the StratosS.

5. Connect the other end of the dual interface cable (MLPN 57-57000x-N-3) into the appropriate communication port on the

host’s scale.

6. Plug the optional remote display cable (MLPN 46-00248x or 46-00249x) into the 10-pin socket labeled Scale to Display

on the bottom of the StratosS.

7. Plug the external power supply (46-002xx) into the 3-pin Molex socket labeled, DC Power In, on the bottom of the

StratosS.

Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet

should be located near the equipment and be easily accessible.

Metrologic recommends using a switched AC outlet. The switch should be located on the operator’s side of the

checkout counter in close proximity to the StratosS to facilitate calibration and service of the unit.

8. Connect AC power to the transformer. If the AC outlet is equipped with an on/off switch, turn the power on.

9. Turn on the host system.