* *
IB5
LP6
SM3
SM2
SM1
IB6
LP5
Enter/Exit Program Mode
44
ScanPal Data Collector
The Metrologic ScanPal is a data collection terminal used with the MS951
scanner. The following bar codes are used to configure the scanner to
communicate with the ScanPal.
Default to ScanPal When this option is selected, the scan-
Communication Parameters ner’s parameters will automatically
change to the default settings of the
ScanPal data collector.
Transmit Code ID When this mode is selected, the scanner
will transmit a code type identifier before
each bar code. This feature is used with
the ScanPal for special applications.
**Do Not Transmit Code ID
Test Modes
Scan Count When this option is scanned, the scanner
will enter scan count test mode. The firm-
ware number of the scanner will also be
transmitted to the host device. Do not
enable this feature unless instructed to do
so by a Metrologic representative.
Scannability When this option is enabled, the scanner
will enter scannability test mode. Do not
enable this feature unless instructed to do so
by a Metrologic representative.
*Normal Scan When this option is selected, the scanner
will exit from scannability or scan count
test modes.
Transmit Scanner Parameters When this option is selected, the scanner
will transmit (via Keyboard Wedge and at
9600 baud via RS-232) its current
configuration.