10
FULL SPEED USB WITH POWER FROM REGISTER SCANNER
INSTALLATION 1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector into the 10-pin modular jack on the
bottom of the charger cradle. You will hear a ‘click’ when the connection is
made.
3. Connect the female DC power jack of USB cable to the center power jack on
the bottom of the charger cradle.
4. Connect the USB Type A plus power connector to the USB port on the host
system.
5. Turn on the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV ( Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the
power source should meet applicable performance requirements for a limited power source.