17
AUDIBLE INDICATORS When the scanner is in operation, it provides audible feedback. These sounds
indicate the status of the scanner. Eight settings are available for the tone of the
beeper (normal, 6 alternate tones and no tone). To change the tones, refer to the
MetroSelect Single-Line Programming Guide (MLPN 00-02544B) or MetroSet2’s
help files.
One Beep
After establishing communication, when the scanner is put
into cradle correctly, the scanner will beep once.
When the scanner successfully reads a bar code, the white
LED will flash and the scanner beeps once.
When the scanner is set into full sleep mode by pressing
the CodeGate button for 3 seconds, the scanner will give a
longer beep.
Two Beeps
When the scanner has a low battery voltage, it will give two
beeps after a successful scan and flash the amber LED
every 5 seconds.
When there is a Flash ROM upgrade needed, the scanner
will beep twice followed by alternating flashing of the blue
and white LEDs.
If the scanner gives out two combined high and low tones
and flashes blue LED, this indicates the communication
between scanner and cradle is broken.
Three Beeps
When entering configuration mode, the white LED will flash
while the scanner simultaneously beeps three times. Upon
exiting configuration mode, the scanner will beep three
times again, then the white LED will stop flashing.
When scanning a Bluetooth Address bar code, the scanner
will beep three times. A few seconds later, the scanner’s
blue LED flashes, and sounds a 3-combination tone. This
indicates communication between the scanner and the
cradle has been successfully established.
When using single-code-programming, the scanner will
sound a 3-combination tone (a short pause followed by a
high tone and a low tone). This indicates a single
configuration bar code has successfully configured the
scanner.
Razzberry Tones
This tone indicates a type of failure. Refer to “Failure
Modes" on page 16.