Metz 28 CS-2 instruction manual Flash exposure correction value EV

“TELE” flash on the LC display. Then press the “-” key to set “WIDE”.

Use of the telephoto attachment (“TELE”)

When using the 85 mm telephoto attachment

(7 mm height) in front of the reflector, continue de-

pressing the pre-select key until “TELE” and / or “WIDE” flash on the LC display. Then press the “+” key to set “TELE”.

Working without an attachment

When using the flash unit without an attachment

continue depressing the pre-select key until “TELE” and / or “WIDE” flash on the LC display. Then press the “-” and “+” keys until “TELE” and “WIDE” are simultaneously displayed.

The setting becomes instantly effective and is auto- matically stored after 5 s. The display then indi- cates either “WIDE” or “TELE” depending on the setting. “WIDE” and “TELE” are no longer display- ed after storage if no reflector attachment is used.

Please refer to the instructions in Chapter 3.

9.4 Flash exposure correction value EV

In various exposure situations it may be necessary to specifically influence the flash intensity of the slave flash unit, i.e. increase or decrease the inten- sity. A corresponding flash exposure correction value can be set on the flash unit for this purpose.

☞A flash exposure correction value can only be set in the auto flash mode A!

Continue depressing the pre-select key on the flash unit until “EV” and the correction value flash on the display. While the displays are flashing set the desired correction value between -3 and +3 EV- in one-third increments. The setting becomes instantly effective and is automatically stored after 5 s. After ￿ storage the LC display shows again the f-stop in place

of the correction value and “EV” flashes to indicate that an exposure correction value has been set.

To delete the correction value, set the correction value “0.0” on the flash unit. “EV” ceases to be displayed after automatic storage.

103