The Fan
Heated air from the fireplace is forced into the room by an internal fan. The control for the fan is in the right corner of the unit.
“Off” is to the far left.
“High” is just to the right of “Off.” “Low” is to the far right.
Variable adjustment of the fans is possible with any set- ting between “high” and “low.”
For best results, coordinate fan speed with the setting of the primary air control. For example, when the air control lever is set at “low,” also set the fan at “low.” With the air control set for maximum heat, set the fan at “high.”
Glass Doors
The EWF36A is intended for use with the doors fully closed or fully open only when optional spark screen is installed. (Fig. 30) NOTE: When operated with the doors open and spark screen in place, the damper MUST be in the open position.
Correct | Correct | Optional |
KT108b |
| Spark |
| Screen |
Fig. 30 Correct door position during operation.
Burn Only High-Quality Wood
The EWF36A is designed to burn natural wood only; do not burn fuels other than that for which it was designed.
You will enjoy the best results when burning wood that has been adequately
The best hardwood fuels include oak, maple, beech, ash, and hickory that has been split, stacked, and air- dried outside under cover for at least one year.
For areas that do not have a supply of hardwood, com- monly burned softwoods include tamarack, yellow pine, white pine, Eastern red cedar, fir, and redwood. These too should be properly dried. Your EWF36A will accept wood up to 24” (610 mm). Longer wood pieces work better than short ones.
Wood should be stored under cover to maintain dry- ness, and should be dried at least six months for optimum heating and
Vermont Castings EWF36A
Use the Air Control Settings
that Work Best for You
No single air control setting will fit every situation. Each installation will differ depending on the quality of the fuel, the amount of heat desired, and how long you wish the fire to burn.
The control setting also depends on your particular installation’s “draft,” or the force that moves air from the stove up through the chimney. Draft is affected by such things as the length, type, and location of the chimney, local geography, nearby obstructions, and other factors.
Too much draft may cause excessive temperatures in the fireplace. On the other hand, too little draft can cause backpuffing into the room and/or the “plugging” of the chimney or combustor.
How do you know if your draft is excessively high or low? Symptoms of too much draft include an uncontrol- lable burn or a
In some newer homes that are
Another option for getting more combustion air to the stove is to duct air directly from the outside to the stove. In fact, in some areas provisions for outside combustion air are required in all new construction.
Your EWF36A is designed so that it is possible to incorporate outside air for combustion. Directions for installing the optional
When first using the stove, keep track of the settings of the air controls. You will quickly find that a specific setting will give you a fixed amount of heat. It may take a week or two to determine the amount of heat and the length of burn you should expect from various settings.
Most installations do not require a large amount of combustion air, especially if adequate draft is available.
Do not for any reason attempt to increase the firing of your heater by altering the air control adjustment range outlined in these directions.
20005167 | 19 |
