Vermont Castings EWF36A
Optional Accessories
Fan Kit
FK26 Fan
The FK26 fan helps distribute heated air from within the firebox out into the room. The fan is controlled by a snapstat that turns power on and off as the firebox tem- perature rises above and falls below a preset tempera- ture. A rheostat provides for variable fan speeds.
Specifications
115 Volt / 60Hz / .75 Amps
Maintenance
The fan itself does not require regular maintenance, however, periodic cleaning of the fan and the surround- ing area is required.
Installation
1.Place fan assembly at the back of the unit between hearth supports. Attach using velcro strips provided. (Fig. 33)
2.Install thermal sensor (snapstat) on bottom of firebox by sliding between bracket and firebox.
3.Place electronic fan speed control box (rheostat) to side bracket. Fasten fan speed control box with #10 - 24 hex nuts.
4.If the
The fireplace, when installed must be electrically connected and grounded in ac-
cordance with local codes, with the current CSA C22.1 Canadian Electrical Code or for US installations, follow local codes and the National Electrical Code, ANSI/NFPA No. 70.
Any electrical rewiring of this fan must be complet- ed by a qualified electrician.
Turn off all power before hook up.
|
| Heat Sensor | Electrical | |
| Fan | (Snapstat) | ||
| Box |
| ||
|
|
|
| |
|
| Fan Speed Switch |
| |
|
| (Rheostat) |
| FP1323 |
|
|
|
| |
Fig. 33 | FK26 fan placement. |
|
| |
Trim Kits
A cast face trim kit and a cast louvre kit are available to enhance the look of your EWF36A fireplace. Installation instructions are included with the kit.
Model Description
EWF36ACFTK | Cast Face Trim Kit |
EWF36ACLK | Cast Louvre Kit |
Screen Kit
An optional spark screen, EWF36S, is available to allow the fireplace to be operated with the doors fully open.
NOTE: When operated with the doors open and the screen in place, the damper MUST be in the open position.
20005167 | 29 |
