MicroBoards Technology Orbit II 6.7 Batch Mode , 6.8 Track Extraction (Audio CD Only) ,

Orbit II Disc Copier Reference Manual – Revision K

Load Master Disc / press YES key..

END EXTRACTION?

Extract? 01/12

6.7 Batch Mode

Batch mode allows you to load masters and blanks into the input hopper to duplicate from multiple masters

while leaving the Orbit II unattended. Masters are automatically detected and stored temporarily on the

internal hard drive, then copied to each blank that follows until the next master is detected.

When using Batch mode, the first disc inserted must be a master. Also, masters must be separated by at

least one blank disc.

To enter Batch Mode:

• Press Yes when the display reads

• Load the first master, then the number of blanks required, then the next master and blanks.

Repeat as necessary, with a limit of 50 discs in the input hopper.

• Press Yes at to begin the batch mode copy. Pressing No will allow you

to choose the other batch copy option,

• When the duplication is complete and the input hopper is empty, you will be given the option of

adding discs to the input hopper and continuing, or ending the batch copy. Press Yes after adding

media to continue the batch copy, or press No to halt the batch copy and return to the batch mode

option selected in the step above.

NOTE: Exiting batch mode will set the master source as Disc to Disc for non-batch Copy or non-batch

Copy and Compare. If you had selected a hard drive source prior to the batch copy and want to

use that hard drive source again, you will need to reset the System Setup to that hard drive source

(see section 6.3).

Batch Mode will not duplicate CD+G or allow duplication by Track Extraction.

6.8 Track Extraction (Audio CD Only)

NOTE: TRACKS CAN ONLY BE EXTRACTED FROM AUDIO CD MASTERS

To select Track Extraction:

• Press Yes when the display reads . The reader drive will open.

• Insert a master audio disc in the reader at the

display prompt. The Orbit II will retract the reader tray and analyze the master disc after the Yes

button is pressed.

• Press Yes at to select the track for extraction or No to skip this

track. In this example, the master has a total of 12 tracks.

• After selecting or skipping the last track, press Yes to finish extraction or No to reselect tracks from

this master.

Since this master has a total of 12 tracks, you are asked if you would

like to end the extraction after the 12th track.

Trk Extraction?

Batch Mode?

B_Copy?

B_Copy & Compare?