MicroBoards Technology Orbit II Copy Disc to Disc?

Orbit II Disc Copier Reference Manual – Revision K

5.4 Initial Orbit II Copying System Checks

 Turn Power On by operating the switch on the external Power Supply. The system’s power on

sequence will take a few seconds, but it should conclude with the display shown in the photograph

below. If the Copy CD-to-CD? prompt appears, your unit’s electronics are functioning properly.

Proceed with step 5.5 Navigating the Orbit II Menu Tree.

 If you do not see anything on the display, check the external power supply connections. Make

sure the red light on the external power supply goes on when you turn on the power switch. If the

light does not go on, either the AC Receptacle you used does not have power, or the external

power supply may be defective. Contact Microboards Technology Technical Support.

 If the display has any other message, or is unreadable, Contact Microboards Technology Technical

Support.

5.5 Navigating the Orbit II Menu Tree

This is the top level of the Orbit II operating system menu tree.

Orbit II Display and 2 Key Control Panel

1 Line x 16 Character

Display

2 Key

Keyboard

Copy Disc to Disc?