Orbit II Disc Copier Reference Manual – Revision K
39
Error Message: Problem Description:
!! Bad Copy!! The copy CD is bad and will be rejected. This message may briefly appear
during any of Orbit II’s operating modes.
!!ERROR!! No CD Reader! This message would appear during a power on self-test if the copy controller did
not locate a compatible CD Reader. Contact Microboards Technology Technical
Support.
!!ERROR!! No CD-R Drives! This message would appear during a power on self-test if the copy controller did
not locate a compatible CD-R/CD-RW Writer. Contact Microboards Technology
Technical Support.
!!ERROR!! Disc is Blank! This message would appear at the start of a copy or compare job if the copy
controller could not read the disc that is in the CD Reader. Check your master
CD, CD-R, or CD-RW discs, and try again. If this message persists, contact
Microboards Technology Technical Support.
Setup Error The user Setup file has been corrupted. Turn the external power supply OFF,
and leave it OFF for a few moments. When you turn your Orbit II System back
ON it will reset the user Setup file to the factory default values of Burn CD? Yes
and 52x Write? Yes. If you are not using these default settings, make the
appropriate System Setup? changes before you use your Orbit II System.
!!WARNING!! Copier Your Orbit II System Setup has been changed to Burn CD? No. If you want to
is in SIMULATE mode proceed with the operation you selected press the Yes key. If you do not want
to proceed in simulate mode, press the No key and change the System Setup?.
Master Drive Error The Reader drive could not successfully read from the master. If you have been
able to successfully duplicate the master previously, use a copy as the master for
duplication purposes. If duplication is successful from the copy, the master may
contain burn errors from the original mastering or may be physically damaged;
continue using the copy as the master. If the copy returns the same error,
contact Microboards Technology Technical Support.