MicroNet Technology SP3367N user manual Dtim, Mcs

DTIM	Determines the interval the Access Point will send its
	broadcast traffic. The range is from 1 to 255 and the default
	value is 3 beacons.
	802.11b – It only allows 802.11b wireless network client to
	connect to this router (maximum transfer rate 11Mbps).
	802.11g – It only allows 802.11g wireless network client to
	connect to this router (maximum transfer rate 54Mbps).
	802.11b+g – It only allows 802.11b and 802.11g wireless
	network client to connect to this router (maximum transfer rate
	11Mbps for 802.11b clients, and maximum 54Mbps for
	802.11g clients).
	802.11n – It only allows 802.11n wireless network client to
	connect to this router (maximum transfer rate 300Mbps).
	802.11g+n – It allows 802.11g, and 802.11n wireless network
Wireless Mode	client to connect to this router (maximum transfer rate
	54Mbps for 802.11g clients, and maximum 300Mbps for
	802.11n clients).
	802.11b+g+n – It allows 802.11b, 802.11g, and 802.11n
	wireless network client to connect to this router (maximum
	transfer rate 11Mbps for 802.11b clients, maximum 54Mbps
	for 802.11g clients, and maximum 300Mbps for 802.11n
	clients).
	NOTE: For 802.11b and 802.11g mode, the signals can be
	transmitted only by antenna 1 (The antenna in the right side
	of the rear panel).
	For 802.11n mode, the router is operating in a 2T3R Spatial
	Multiplexing MIMO configuration. 2 antennas are for signal
	transmitting and 3 antennas are for signal receiving.

11n Settings

Parameter		Description
Channel Bandwidth		Set channel width of wireless radio. Do not modify default
		value if you don’t know what it is, default setting is ‘20/40
		MHz’.
Extension Channel		Select the extension channel to above or below the control
		channel while 40MHz channel bandwidth is selected. Do not
		modify the default value if you don’t know what it is.
Guard Interval		It is one of several draft-n features designed to improve
		efficiency. Select 400nsec to provide a shorter delay between
		transmission frames in 11n network. The throughput in
		400nec guard interval is better than 800nsec guard interval.
		Select MCS 0-15 to configure the data rate of 11n network.
MCS		When MCS 15 is selected, the data rate is up to 300Mbps. It
		is recommended to set “Auto” and the router will negotiate
		with wireless clients to operate in a proper data rate.
SSID Index		This router can support multiple SSIDs. By default, this
		function is disabled.
	27