Microsoft E60, TC4100, LC2000, E800 Introduction, Requirements, Frequently Asked Questions APPENDIX

Tip #3. Upgrading Small Business Server 2000 from Uniprocessor HAL to Multiprocessor

HAL

Tip #4. Small Business Server 2000 Driver Signatures

Tip #5. Upgrading D5013B NIC Drivers for Small Business Server 2000 Tip #6. Installation Fails to Boot after First Reboot

Tip #7. Small Business Server 2000 Recovery Options

Tip #8. Terminal Server Service is only support the NetServer L Series

Frequently Asked Questions

APPENDIX

On-Line Information and Software Sources

Introduction

This document was created by Hewlett-Packard for the purpose of helping you install Microsoft Small Business Server 2000 on your HP NetServer based on procedures tested by HP. The objective of this document is to provide the information needed to achieve the following tasks.

￿￿Install Small Business Server 2000 from Diskette or CD-ROM

￿￿Create boot diskettes from CD-ROM

￿￿Configure system as Domain Controller and DNS Server

￿￿Change IP Address

￿￿Provide installation troubleshooting tips and tricks

Before you start installing or upgrading to Small Business Server 2000 check the following documents and make sure you develop an action plan to complete the installation. Use the following informational resources to help you.

￿￿read1st.txt (Small Business Server 2000 CD-ROM)

￿￿readme.doc (Small Business Server 2000 CD-ROM)

￿￿Troubleshooting Tips and Tricks at the end of this document.

Requirements

￿￿Microsoft Small Business Server 2000 CD-ROM.

￿￿Target system to be tested with minimum of P166 Processor and 64Meg of RAM (128Meg Recommended).

￿￿One or more Network Interface Cards (NIC).