Connecting To An Audio Source | Microtek CX4 instruction

Image 21

Microtek CX4 manual Connecting To An Audio Source, Connection of an audio cable from a computer source

Contents

Page INTRODUCTION Safety Instructions If the power cable or plug is damaged or frays Where To Get Help Transporting Your Projector Remote Control Information Warning： Remote Control Briefing Functions INSTALLATION Unpacking The Projector Setting Up The Projector Do not mix used and new batteries Connecting To A Desktop Computer Connecting To A Computer 8. Tighten all connector screws to ensure secure connections 4. Connect the Control Cable to the Control port of the projector5. Remove the computer mouse cable Connecting To A Notebook DVI SourceData Projector Connecting To A Macintosh Desktop Computer Connecting To A Macintosh PowerBook Connecting To A Set-top Box Connecting To A Video Source The steps of connecting the projector to the video source Page Connection of an audio cable from a computer source Connecting To An Audio Source Connection of an audio cable from a video audio source Connecting To An External Speaker Speaker or PAData Projector THIS PROJECTOR HOW TO OPERATE Turning The Equipment On And Off Page The Focus and Zoom Functions How To Adjust The Projected Image The Resize key The Auto Key How To Operate This Projector Buttons The Buttons on the Operation Panel of the Projector & Their FunctionsFunctions like Note The ZOOM & FOCUS functions are not suitable to this model The Buttons on the Remote Control & Their Functions Examine The Projector Status The life of the lamp will soon end, please prepare aThe life of the lamp has ended, please replace with USING THE OSD MENU How To Change OSD Settings How To Access The OSD MenuOSD Menu Brightness Contrast Black LevelPosition Image Auto Configuration InformationMiscellaneous Input Select VideoSave Keystone VolumeProjection Mode Mouse Language MAINTENANCE Cleaning the Projector Case Cleaning the LensCleaning the Air Filter The Steps of Cleaning the Air Filter The Steps of Replacing a Lamp Replacing The Projector Lamp 1. Turn the power of the projector off and unplug the power cord 3. Loosen the screws on the lamp case with a coin or screw driver4. Lift up the handle and pull out the lamp 8. Position the lamp cover you took off in step 7. Tighten the lamp case you took off in step TROUBLESHOOTING When the Power Led Indicator does not light up Problem With The ProjectorWhen the Projector Lamp does not light up The Power Indicator remains red Problems With The Image Or Sound The Power Indicator is blinking redNo image appears on the screen Abnormal Image Coloring The words ‘No Signal’ appear on the screen No response with remote control No SoundUnstable Image Displayed by VHS Video Player TECHNICAL SPECIFICATIONS General OpticalProjector lamp Mechanical with lens and feet ElectricalEnvironmental Resize Display Supported Monitor Displays Support Modes Computer In and Monitor Connector Pin Assignments