27
42" PLASMA DISPLAY

• Selecting the Video Input Source

Press the TV/VIDEO button on the remote control or the
SOURCE button on the PDP unit to select video input source
from another device connected to your PDP. For example, if
you are connected to HDTV (YPbPr), select “HDTV”, then
ENTER to confirm your selection.
You can also set the video input source through the on-screen
menu. See the section, “Selecting Input Source” in Chapter 5:
Using the PDP’s Features.
Selecting the TV System
There are several TV standards in use around the world. The
two most common standards are NTSC and PAL. This product
supports both these standards and also SECAM. Your dealer
can tell you which TV system is in use in your area.
You can set the TV input standard through the on-screen
menu.
1. Press the MENU button on the remote control or on the
PDP unit.
2. Press the UP/DOWN ( /) button on the remote control to
select “TV”, then ENTER to confirm your selection.
3. Press the UP/DOWN ( /) button on the remote control to
select “System”, then LEFT/RIGHT ( /) to switch your
system.
Scanning for Channels
Your PDP can automatically scan for active channels. After
scanning for channels, only active channels appear when you
move through channels using CH or CH .
To scan for active channels, follow these steps:
1. Press the CH SCAN button on the remote control.
2. Allow some time for the TV to scan channels. Do not use
other TV functions until scanning is completed.
You can also scan for channels using the on-screen
menu. See the section, “Adjusting TV Settings” in
Chapter 5: Using the PDP’s Features.