Middleby Marshall PS528G installation manual Maintenance, H. Attaching Drive Chain

SECTION 4 MAINTENANCE

6.  Reconnect the inside master links (Figure 4-29.)

H.  Attaching Drive Chain

1.  If drive sprocket assembly was removed reassemble it into the conveyor drive shaft. Be sure flat on end of drive shaft aligns with set screw in conveyor shaft collar. Once in place tighten 3/32″ set screw.

2.  Lift conveyor and install drive chain to conveyor drive sprocket and motor sprocket.

Figure 4-29.

NOTE: The outside master links have right and left sides to them. The right edge master link has an open hook facing you as shown in Figure 4-30. This will match up with the outer edges of the conveyor belt. Remember this hook travels backwards on the conveyor.

Direction of travel

Figure 4-32.

3.  The angle plate located on the underside of the con- veyor must be against the lower end plug. This is true on both sides of oven.

Figure 4-30.

7.  Reconnect the outside master links.

8.  Replace all parts removed from the oven.

Crumb Pan

Mounting

Bracket

Lower End Plug

Figure 4-33.

Figure 4-31.

38