Middleby Marshall PS536ES I. Replacing Conveyor Belt, J. Attaching Drive Chain, Lower End Plug

SECTION 4

MAINTENANCE

6. Reconnect the inside master links (Figure 4-30.)

Figure 4-30.

NOTE: The outside master links have right and left sides to them. The right edge master link has an open hook facing you as shown in Figure 4-31. This will match up with the outer edges of the conveyor belt. Remember this hook travels backwards on the conveyor.

Direction of travel

Figure 4-31.

7.Reconnect the outside master links.

8.Replace all parts removed from the oven.

I. Replacing Conveyor Belt

If a section of the conveyor belt needs replacing it can be done with the conveyor assembly either in or out of the oven. The section of the conveyor belt furnished with the oven in the installation kit may then be used to replace a section. Follow the preceding procedure “H. Conveyor belt link removal” which outlines the disassembly procedure.

J. Attaching Drive Chain

1.If drive sprocket assembly was removed reassemble it into the conveyor drive shaft. Be sure flat on end of drive

shaft aligns with set screw in conveyor shaft collar. Once in place tighten 3/32″ set screw.

2.Lift conveyor and install drive chain to conveyor drive sprocket and motor sprocket.

Figure 4-33.

3.The angle plate located on the underside of the con- veyor must be against the lower end plug. This is true on both sides of oven.

Crumb Pan

Mounting

Bracket

Figure 4-32. Lower End Plug

Figure 4-34.

38