Section Maintenance | Middleby Marshall PS536ES instruction

SECTION 4 MAINTENANCE

6. Make sure bronze washer is in between the two halves.

9. Loosen the split locking collar.

Figure 4-42.

7.Place the idler shaft assembly back into place and reinstall the adjustment screws.

Figure 4-43.

8.Loosen the set screw on each conveyor drive sprocket and remove sprockets.

Figure 4-44.

Figure 4-45.

10.Remove drive shafts by sliding to right then lifting the left side. Follow cleaning and lubricating procedures out- lined in Steps 4-6.

Figure 4-46.

11.Reassemble conveyor drive shafts into frame, mak- ing sure nylon spacer is in place.

Figure 4-47.