Owner’s Manual for the P-20 (Itinerant Radio)

You can have only two channels in the active mode at a time. If you try to activate more than two channels, the radio will beep two or three times. Check and turn off any other active channels and try again.

4.To change the status of a channel, use the /\ or \/ buttons to select the programmed channel to be removed or added from use. Press the PTT button to change the status from “oN” to “FF”. Select the new active channel with the /\ or \/ buttons. Press the “ENTER” button to return to normal operation.

ADJUSTING THE VOLUME

Rotate the ON/OFF Volume control (7) clockwise to increase the volume. Rotate the ON/OFF Volume control counter clockwise to decrease the volume.

ADJUSTING THE SQUELCH

Squelch is preset, no adjustment is available.

USING THE CALL FUNCTION

Press and release the “CALL” button (5) on the side of the radio.

This will cause the radio to transmit a tone to alert the other people in your group to listen for a message.

Use of the call function is discouraged if using the 22-405 or the 22-540

USING THE MONITOR FUNCTION

1. Press and release the “MON” button (3) on the side of the radio to open the squelch.

This allows you to over ride the squelch and the “CTCSS” or “DCS” tones. This is useful to monitor the channel before you transmit to ensure there is not someone using the channel when you have “CTCSS” or “DCS” tones programmed. This is also useful if you suspect someone in your group does not have the proper “CTCSS” or “DCS” tones programmed.

2. Press and release the “MON” button or wait 10 seconds to restore the squelch to normal.

TURNING ON OR OFF THE BUTTON PRESS BEEP

1.With the radio turned off, press and hold the “ENTER” button (8) and turn the radio on. The radio will display all segments available on the display and sound the power up tone. Release the “ENTER” button when the radio powers up. The display will show FFor oNdepending on the previous setting, and below in smaller letters “BEEP”

2.Press and release the “/\” or “\/” button to change the setting.

3.The setting oNis Beep on. The setting FFis Beep off.

4.Press and release the “ENTER” button to return to operating mode.

TURNING ON THE DISPLAY BACKLIGHT

Press and release the “ENTER” button (8). A beep will be heard (if enabled). The backlight will stay on for about 5 seconds then turn off.

TURNING THE ROGER BEEP ON OR OFF

Roger beep is a sound the radio transmits when you release the “PTT” button (4).

1.With the radio turned off, press and hold the “ENTER” button and turn the radio on. The radio will display all segments available on the display and sound the power up tone. Release the “ENTER” button when the radio powers up. The display will show FFor oNdepending on the previous setting, and below in smaller letters “BEEP”

2.Press and release repeatedly the “F” button (usually once). An icon of a musical note will be displayed above oNor FFon the display.

3.Press and release the “/\” or “\/” button to change the setting.

The setting oNis Roger beep on. The setting FFis Roger beep off.

The Roger beep is the same sound as the Power Up tone

4. Press and release the “ENTER” button to return to operating mode.

Use of roger beep is discouraged when earphones or headsets are in use.

 

http://www.midlandradio.com

Page 8 of 16

 

 

 

 

 

 

 

 

 

Page 8
Image 8
Midland Radio P-20 Adjusting the Volume, Adjusting the Squelch, Using the Call Function, Using the Monitor Function