Features and Location of Contols

Owner’s Manual for the P-20 (Itinerant Radio)

1 VOX button	2-Up/Down Buttons	3-Monitor Button 4-Push to Talk Button
5-Call Button	6-Accessory jacks	7-On/Off Volume Control 8-Enter Button
9-Function Button	10-charging contacts 11-Charge Jack

THE RADIO MUST NOT BE SCANNING OR TRANSMITTING AND THE CONTOLS NOT LOCKED BEFORE THE CONTROLS WILL WORK PROPERLY.

TURNING THE RADIO ON OR OFF

Rotate the ON/OFF Volume control (7) clockwise to turn the radio ON. An audible tone will indicate the radio is on. The display will go through a 1 second self test and go to operation mode. Rotate the ON/OFF Volume control counter clockwise to turn the radio off.

LOCKING THE CONTROLS

Press and hold the “MON” button (3) for about 3 seconds a beep (if enabled) will be heard and the KEY icon will be displayed. The “PTT” and the “CALL” are the only buttons active. If any other buttons are pressed 3 quick beeps will be heard.

UNLOCKING THE CONTROLS

Press and hold the “MON” button (3) for about 3 seconds a beep (if enabled) will be heard and the KEY icon will not be displayed.

SELECTING THE CHANNEL

Press the “/\” or “\/” button (2) to select the desired channel.

(ONLY IF TWO CHANNELS ARE ACTIVE)

If only one channel is programmed and the /\ or \/ button is pressed 2 quick beeps will be heard.

PROGRAMMING THE ACTIVE CHANNEL

1.With the radio turned off, press and hold the “ENTER” button and turn the radio on. Release the button after the power-up tone.

2.Press the “F” button twice or until you see “1-oN” or “1-FF” displayed.

3.To review channel programming status, press “/\” or “\/” buttons to display each channel number. The channel number followed by “oN” indicates an active channel. A channel number followed by-“ FF” indicates an inactive frequency.

	http://www.midlandradio.com	Page 7 of 16

Midland Radio P-20 owner manual Features and Location of Contols, Turning the Radio on or OFF

Models: P-20