Maintenance and Care
Replacing the roller brush drive belt
The Powerbrush housing must be opened in order to replace the drive belt.
Remove the roller cover by loosening the two lock screws on the bottom of the Powerbrush using a coin or screwdriver. Remove the roller cover.
Pull up the roller brush until it releases from the main housing, and slide the drive belt over the end of the brush. Set the roller brush aside.
Remove the 4 screws in the lower housing of the Powerbrush , then separate the lower housing from the upper housing .
Install a new drive belt by slipping it over the gear on the motor shaft and the toothed side of the roller brush.
Reassemble the Powerbrush by reversing the procedure.
22
