IMPORTANT INSTALLATION SAFETY INSTRUCTIONS
Note to the installer:
Please leave this instruction book with the consumer for the local electrical inspector’s use.
The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.
The cabinetry and venting hood should be installed first to prevent damage to the combiset.
The countertop must be bonded with heat resistant (212°F/100°C) adhesive to prevent distortion or dissolving.
Any back splashes should be
The combiset must not be installed over a dishwasher, washer, dryer, refrigerator or freezer. Heat radiated by the combiset may damage them.
To eliminate the risk of burns or fire by reaching over heated surfaces cabinet storage space above the appliance should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5" (127 mm) beyond the bottom of the cabinets.
This appliance must not be used in a
Do not install this appliance above an oven unless the countertop is at least 1 9/16" (40 mm) thick.
You must ensure the power cable for the appliance will not come into contact with the floor panel after installation, nor be subject to any mechanical strain.
The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. See "Sealing".
Keep this instruction book in a safe place for reference and pass it on to any future user.
24