Installation |
|
| ^ Screw the mounting plate through the |
| ceiling and into the structural framing |
| using 8 x 60 lag bolts and washers. |
| Once tight, make sure that the |
^ Insert the short edge of the two | mounting plate can safely support |
the weight of the hood. | |
spring clips into their slots from |
|
below and pivot them 90° so that the |
|
tab faces the center of the mounting |
|
brake. |
|
^Pull the power cord through the mounting plate.
^Insert the four countersunk screws
M 6 x 20 into the recessed holes from above.
^Tape the screws from above to prevent them from being pushed upwards when the nuts are tightened.
26
