Installation
Attach the spacer bar to the guide rail (2) located behind the light tube.
Fitting the light tube cover
– DA 262 i
Pull off the transit strips on each side.
Fitting the cover caps
For cooker hoods without a front panel or lightshield:
Position the light tube cover and screw into place (see diagram).
– DA 272 i, DA 292 i |
Attach the extension pieces supplied to the light tube cover, then position the now extended light tube cover and screw into place.
Push the Allen screws from the accessory kit onto the cover caps until the screw heads lie directly under the holes in the cover caps. Secure the cover caps on both sides of the deflector plate using the Allen screws.
Preparing the lightshield
Removing the transit strips
Pull the deflector plate out to its limit.
Lightshields . . .
. . . weighing up to 600 g can be fitted normally.
. . . Those weighing over 600 g need to have the springs in the snap fittings pre- tensioned:
19
