IMPORTANT SAFETY INSTRUCTIONS
d) Before connecting the appliance to the power supply make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply.
This data must correspond to prevent appliance damage. If in doubt consult a qualified electrician.
Installation
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
e) Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and other work by unqualified persons could be dangerous.
f) Only open the housing as described in the enclosed "Installation diagram" and in the "Cleaning and care" section of this manual. Under no circumstances should any other parts of the housing be opened. Tampering with electrical connections or components and mechanical parts is highly dangerous to the user and can cause operation faults.
g) Before discarding an old appliance, disconnect it from the power supply and remove the power cord to prevent hazards.
a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including
b) Sufficient air is needed for combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
c) When cutting or drilling into the
wall or ceiling, do not damage electrical wiring and other hidden utilities.
Use
Do not use a steam cleaner to clean the appliance. Steam could penetrate electrical components and cause a short circuit.
d) Ducted hoods must always be vented to the outdoors.
e) Any fittings, sealant, or materials used to install the ductwork must be made of approved
WARNING
TO REDUCE THE RISK OF FIRE USE ONLY METAL DUCTWORK.
5
