TRENDnet TEG-S3000I manual Rear Panel, Desktop Installation

	Off	Power is not connected
	Green	The port is connecting with the device.
LNK/ACT
	Blinks	The port is receiving or transmitting data.
	Off	No device attached.
	Orange	The port is operating in Full-duplex mode.
FDX/COL	Blinks	Collision of Packets occurs in the port.
	Off	In half-duplex mode
	Table 2-1. The Description of LED Indicators

Rear Panel

A module slot, 3-pronged power plug, 2 fans, a power switch button, and a console port are located at the rear Panel of the TEG-S3000i chassis switch as shown in Figure 2-1. The Switch will work with AC power in the range of 100-240V AC, 50-60Hz.

Figure 2-1. The Rear Panel of the TEG-S3000i chassis switch

Desktop Installation

Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface where you put your Switch should be clean, smooth, level and sturdy. Make sure there is enough clearance around the Switch to allow attachment of cables, power cord and air circulation.

12