Additional options
Buzzer
A signal sounds at the end of a program and when a fault occurs.
The buzzer at the end of a program sounds five times in quick succession for up to one hour.
The buzzer for a fault sounds in intervals up to two minutes.
The buzzer is activated by default. It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off.
^Open the door.
^Turn the dishwasher off with "o".
^Press the program button and at the same time turn the dishwasher on with "g".
^Hold the program button for at least 4 seconds until the lower right program indicator comes on.
If it does not come on, start over.
^Press the tab button four times.
The "Gel" indicator flashes four times in intervals.
The time display shows if the program end buzzer is turned on or off.
–"p 1": Buzzer is turned on
–"p 0": Buzzer is turned off
^Press the program button to change the setting.
The setting is saved.
^Turn the dishwasher off with "o".
Default setting
All settings can be reset to the factory default.
^Open the door.
^Turn the dishwasher off "o".
^Press the program button and at the same time turn the dishwasher on "g". Hold the program button for at least 4 seconds until the lower right program indicator comes on.
If it does not come on, start over.
^Press the tab button 12 times.
The "Gel" indicator flashes once long and twice short in intervals.
The time display shows if a setting was changed.
–"p 1": All settings are factory default.
–"p 0": At least one setting was changed.
^To reset the dishwasher to the factory default, press the program button.
The setting is saved.
^Turn the dishwasher off "o".
35
