Miele KF 7544 installation instructions Installation, Location, Ventilation, Fitting the handles

Models: KF 7544

1 44
Download 44 pages 55.08 Kb
Page 36
Image 36
Installation

Installation

Appliances without side wall heating must not be installed "side-by-side" next to another refrigerator or freezer.

Location

It should not be installed where it is ex- posed to direct sunlight or directly adja- cent to a heat-producing appliance such as an oven or a radiator. The ap- pliance should be installed in a dry well ventilated room.

The room temperature should not go above or below the climate range for which the appliance is designed. The higher the ambient temperature of the room the more energy the appliance re- quires to operate.

Do not place any appliance which gives off heat, such as a toaster or microwave oven on top of this appli- ance, as this would increase the ap- pliance’s energy consumption.

Climate range

The appliance is designed for a use within certain climate ranges (ambient temperatures) and should not be used outside this range. The climate range of this appliance is stated on the data plate inside the appliance.

Climate range

Ambient room tempera-

 

ture

 

 

SN

+10 °C to +32 °C

N

+16 °C to +32 °C

ST

+18 °C to +38 °C

T

+18 °C to +43 °C

 

 

Operating in a room which is too cold will cause the cooling system to switch

off for too long causing the internal tem- perature in the appliance to rise with the risk of food deteriorating and going off.

Ventilation

Air at the rear of the appliance gets warm. To ensure sufficient ventilation the ventilation gaps must not be cov- ered over. The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis.

Fitting the handles

If the door hinging does not require changing the handles should now be fitted to the appliance doors.

^Secure handle a to the holes in the door using the screws marked b.

36

Page 36
Image 36
Miele KF 7544 installation instructions Installation, Location, Ventilation, Fitting the handles