Changing the door hinging
^Pull bearing bush d downwards out of hinge bracket e and refit it from above into the hinge bracket.
^Use a screwdriver to remove spacer g and refit it on the opposite side.
Changing over the door handle:
^Remove covers m at the front and slide off to the side.
^Unscrew handle k. Refit handle and stoppers l on the opposite side.
^Slide covers m into position making sure they engage correctly.
Refitting the doors:
^Remove plugs j from door bearing bushes in the doors and refit on the opposite side.
^Hang the upper appliance door on hinge pin c, and close the appliance door.
^Push middle hinge pin f from below through hinge bracket e into the up- per appliance door.
^Check that the door is correctly aligned. If necessary align it using the long slots in hinge bracket e.
^Hang the lower door in hinge bracket e then close the appliance door.
In the following illustration the lower door is not shown in the closed posi- tion to make it easier to see what happens next.
^Turn door support b around, pull hinge pin a out, and refit on the op- posite side.
^Fit both parts into hinge plate f. To do this push hinge pin a through hinge plate f into door support b. Swing door support out, push up- wards and
^Align the lower door with the appli- ance housing using the long slot in hinge plate f. Then tighten screw c.
^Refit plinth fascia d pushing it firmly into position.
^With the lower door open, secure cover e to the front of the plinth fas- cia.
39
