Changing the door hinging
Caution! The top door of the appliance is no longer secured as soon as the hinge bracket is removed when following the instructions below!
^Close the top door of the appliance.
^Loosen the screws m on the top hinge bracket n and remove the hinge bracket by pulling up.
^Carefully lift and remove the top door of the appliance and set aside.
^Make sure that the bearing pin in the middle of the appliance stays in place, otherwise the bottom door of the appliance has no hold!
^Engage the cover h together with the mounting bracket i on the opposite side.
^Now place the cover l on the other side.
Removing the bottom soft-close mechanism:
^Open the bottom door of the appliance.
^Loosen the panel a of the
Be careful not to damage the door seal.
If the door seal is damaged, the appliance door may not close properly and there will not be enough refrigeration!
^Slide the panel a in the direction of the appliance and leave it hanging between the door and the appliance.
^Place the securing device b (supplied with the appliance) on the
With the securing device in place, the joint cannot snap shut. Do not remove the securing device until instructed to!
^From the side, carefully lift off the cover d using a flathead screwdriver.
^If necessary, lift the appliance backwards slightly with the assistance of another person.
52
