Changing the door hinging

^Lift the plugs l out of the door bearing bushing in the appliance door and place it on the other side.

Mounting the bottom door of the appliance:

^Remove the cover a towards the front.

^Pull the cover b off.

^Screw the adjustment foot at the bearing pin c completely in.

^With the assistance of another person, carefully tilt the appliance backwards and pull the bearing pin c down and out.

^Pay attention to the hinge bushing d.

^Loosen the screws e and remove the hinge bracket f.

^Remove the cover g and loosen the screw. Attach both to the other side.

^Screw the hinge bracket f onto the other side with the two outer screws. Do not use the middle screw; this allows later alignment of the appliance door using the outer, elongated holes!

^Unscrew the bearing part h from the hinge bracket f, turn it 180° and screw it into the opposite hole of the hinge bracket.

^Now place the cover b on the other side.

^With the assistance of another person, carefully tilt the appliance backwards and insert the bearing pin c into the hinge bracket f from below. The groove in the bottom of the hinge bracket faces forwards.

^Place the hinge bushing d onto the bearing pin c.

^Put the cover a on.

^Place the lower door of the appliance onto the bearing pin c from above.

^Close the bottom door of the appliance.

54

Page 54
Image 54
Miele KFN 14943 SD ED installation instructions Mounting the bottom door of the appliance