Miele KM6113, KM6117, KM6118, KM6112, KM6116, KM6115 installation instructions Problem solving guide

Problem solving guide

Problem		Possible cause	Remedy
The sensors are		The sensitivity level of the	Make sure that there is no
over-sensitive or do		sensors has changed.	direct light (from the sun or
not react at all.			from an artificial source)
An F lights up in the			falling onto the hob and that
			the surrounding area is not
rear left cooking zone
			too dark.
display and an E lights
up in the rear right			Make sure that there is
cooking zone display			nothing covering the sensors
and numbers appear			or the hob. Take any pans off
in the displays at the			the hob and wipe away any
front.			food deposits.
left	right		Interrupt the power supply to
			the hob for approx. 1 minute.
9	0	A calibration fault has
			If this does not solve the
9	1	occurred after the reset
			problem, please call the
		function has been
9	2		Miele Service department.
		activated or after an
9	3
		interruption to the power
		supply. If the displays do
		not go out after 5 minutes,
		proceed as described
		under "Remedy" on the
		right.
3	7	The overheating	You can use the hob again
4	4	protection mechanism has	as soon as the fault code
		triggered.	goes out (see "Overheating
			protection").
4	7	The fan is either blocked	Make sure it has not been
4	8	or faulty.	blocked by something like a
			fork. Remove the cause of
			the blockage. If the fault
			message appears again, call
			the Miele Service
			Department.
All other fault codes		There is an electronic	Interrupt the power supply to
		fault.	the hob for approx. 1 minute.
			If the problem persists after
			reconnecting the appliance
			to the power supply, please
			contact the Miele Service
			department.

50