Installation
^If it is not aligned correctly, carefully pull it back out of the niche and realign it by slightly adjusting the position of the bracket on the long slots.
^When correctly aligned, insert the third screw a into the middle of the bracket to prevent the bracket moving out of position.
^Slide the appliance into the housing unit, and pull the cable with the plug* through the back of the unit.
^Connect the appliance to the electricity supply.
^Then push the appliance right back into the housing unit as described above.
* Plug shown is for illustration purposes only.
2. Niche height 360 mm
^Remove all the accessories, including the turntable and the roller ring, from the microwave oven cavity.
^Place the microwave oven on its side.
^Unscrew the front left foot and using the same screw fit foot b in its place.
^Then unscrew both back feet and fit a spacer c between each foot and the base plate. Use the two larger screws d for securing these 10 mm higher feet.
^Then take the third spacer c and using one of the two shorter screws taken from the back feet, screw it into the drill hole on the underside of the appliance next to the cable entry point.
^Now proceed as described in "1. Niche height 350 mm".
54
