Display
The display shows a variety of func-
tions:
–it displays how long a programme
has to run in hours and minutes;
–with "Delay start" it displays the time
remaining until the programme starts;
–it displays programmable functions
being selected and de-selected.
Time left display for Cottons and
Minimum Iron programmes
Once a sensor programme has started
the time left for a programme to run will
be calculated by the machine. During
this calculation period the following
bars will flash in the display:
=== ... -== ... == ... . After approx. 1
minute the programme duration will
appear in the display and proceed to
count down in minutes.
The programme duration can vary each
time a programme is run because it is
affected by a variety of factors e.g:
–the moisture content after spinning
–the type of textiles
–the quantity of laundry in the drum
–the ambient room temperature
–fluctuations in the electricity supply
The electronic unit adapts to each
individual load of laundry. The time
remaining for a programme to run
shown in the display is calculated
constantly during a programme. This
means that the time displayed may
fluctuate during the programme. If the
time remaining in the display has
flashing bars in front of it, this indicates
that the programme is about to enter
the cooling down phase and is not
indicative of a fault.
The time remaining displayed should
not be taken as an accurate time
measurement. It is an estimate of when
your laundry should reach the level
dryness you have selected.
Future updates
The indicator lamp marked "PC" is
explained in "After Sales Service".
Electronic lock and programmable
functions
Electronic lock
Prevents the machine being operated
by others.
Programmable functions
Programmable functions enable the
machine to be adapted to suit personal
requirements.
See the relevant section for detailed
instructions.
Guide to the appliance9