Miele W 1930 Pre-wash, Main wash or Rinse, Indicator lamp is, Rinse & hold, Ing?, On indicator

Problem solving guide

What to do if, . . .	Cause . . .	Remedy . . .
. . . the "Pre-wash",	There is an internal prob-	Restart the program. If
"Main wash" or "Rinse	lem.	the indicator lamp starts
1-2" indicator lamp is		flashing again, call the
flashing?		Service Dept.
. . . The "Rinse & hold"	The spin speed selector	Select a spin speed set-
indicator lamp is flash-	has been set to "Without	ting.
ing?	final spin".
. . . The "Final spin" in-	The final spin has not	– Redistribute the laun-
dicator lamp is flash-	taken place. The machine	dry load.
ing?	detected an imbalance.	– Select a spin speed.
		– Turn the program se-
		lector to "Spin".
. . . The "ON" indicator	The child-safety feature is	Go back to the program
lamp is flashing?	activated, and the pro-	originally selected.
	gram has been changed.
. . . The wash is too wet	The spin speed selected	Select a higher spin
after the final spin?	was too low.	speed next time.
	The load was not evenly	Mix large and small items
	distributed in the drum,	in a load to avoid imbal-
	and the laundry was spun	ance.
	at a reduced speed to
	protect the machine.
	The drain pump or lint	Clean the drain pump or
	trap is clogged.	lint trap.
. . . The machine	The four feet are not rest-	Level the machine (see
shakes during the spin	ing evenly on the floor.	Installation Section).
cycle?	The shipping struts have	Remove the shipping
	not been removed.	struts.

26