Milan Technology CERTXFX01(SC) instruction manual Compliance Information, User’S Guide

Models: CERTXFX01 CERTXFX01(SC)

1 4
Download 4 pages 27.35 Kb
Page 1
Image 1
COMPLIANCE INFORMATION

COMPLIANCE INFORMATION

UL Listed

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques appropriées

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

Minneapolis, MN 55344 USA

Redundant Fast Ethernet

100BASE-TX/100BASE-FX 1300 Nanometer Slide-In-Module Media Converters

C/E-R-TX-FX-01, C/E-R-TX-FX-01(SC), C/E-R-TX-FX-01(SM)

USER’S GUIDE

Designed to be installed in the TRANSITION Networks E-MCC-1600 Media Converter Chassis, C/E-R-TX-FX-01 series redundant Fast Ethernetmedia converters connect 100BASE-TX unshielded twisted pair copper to 1300 nm 100BASE-FX multimode OR to 1300 nm 100BASE-FX singlemode fiber. In the event of a failure in the primary copper or fiber connection, a fully redundant secondary connection is made available to the failed copper or fiber connection. Also, the copper and fiber media converter interfaces operate independently, so that a failure on one interface will not force a failure on the other interface.

Media

Conversion

Center

Power Modules

Power

1

In Use

Power

2

In Use

Management

Module

Power

Link

TX

RX

Switches at the side of the media converter allow selection of auto-negotiation and of full/half-duplex. Also, a port select timer (PST) switch* allows the network administrator to set different timer values (used when a primary connection is lost and a secondary connection is made) at each end of the copper/fiber interface.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

Copyright Restrictions

© 1999 TRANSITION Networks.

All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A.

33113.A

C/E-R-TX-FX-01

Provides two (2) RJ-45 twisted pair 100BASE-TX connectors and two (2) sets of RX (receive) and TX (transmit) ST 100BASE-FX connectors to 1300 nm multimode fiber-optic cable.

C/E-R-TX-FX-01(SC)

Provides two (2) RJ-45 twisted pair 100BASE-TX connectors and two (2) sets of RX (receive) and TX (transmit) SC 100BASE-FX connectors to 1300 nm multimode fiber-optic cable.

(*See note on page 5.)

C/E-R-TX-FX-01(SM)

Provides two (2) RJ-45 twisted pair 100BASE-TX connectors and two (2) sets of RX (receive) and TX (transmit) SC 100BASE-FX connectors to 1300 nm singlemode fiber-optic cable.

C/E-R-TX-FX-01 in the Network .

. . . . .2

Installation

. . . . .3

Operation

. . . . .4

Fault Isolation and Correction

. . . . .5

Cable Specifications

. . . . .6

Technical Specifications

. . . . .7

Compliance Information

. . . . .8

Page 1
Image 1
Milan Technology CERTXFX01(SC) instruction manual Compliance Information, User’S Guide, Redundant Fast Ethernet