Brother HL-1260 service manual Error Messages, Error Message Meaning Action

Table 6.3 Error Messages

Error Message	Meaning	Action
31 PRINT OVERRUN	Print overrun	Press the CONTINUE
		switch to start printing
		the next page. Data
		which overran the print
		area on the page cannot
		be printed. Check your
		page protection setting
		with the MODE switch.
		Setting page protection
		to the correct size could
		solve this problem. If
		printing at 600 dpi, you
		may need to add optional
		SIMM memory.
32 BUFFER ERROR	Input buffer overflow	Press the CONTINUE
		switch to resume
		printing. Data lost in
		overflow cannot be
		printed.
34 MEMORY FULL	Work memory overflow	Press the CONTINUE
		switch to resume
		printing. If the same error
		should occur after you
		press the CONTINUE
		switch, turn off the
		printer. Wait a few
		seconds, then turn it on
		again . Reduce the input
		buffer size. Turn off
		”KEEP PCL.” Add SIMM
		memory with power off.
		Download font and the
		font saved in the HDD
		card might cause the
		error, for it occupies the
		same work area as the
		RAM. Memory expansion
		is recommended in that
		case.
40 LINE ERROR	Error in the	When the serial interface
	communications circuit	is used, check the
		communications
		parameters such as baud
		rate, code type, parity,
		and handshake
		protocols. When the
		parallel interface is used,
		check the interface cable
		connection.
41 PRINT CHECK	Error in communication	Turn off the printer. Wait
	with the engine controller	a few seconds, then turn
		it on again. See M-17.

VI - 27