Brother HL-1260 DC Fan Motor, Main PCB, Remove the Simm replace lid, Remove the MIO box

1.7DC Fan Motor

(1)Remove the DC fan motor from the DC fan motor holder by loosening the two screws.

(2)Loosen the screws securing the PCB holder and remove the entire DC fan motor holder.

(3)Remove the fan harness connector from the main PCB assy.

Screw

Fan connector

Figure 4.9

1.8 Main PCB

Note: If replacing the main PCB with a new one, follow the step in the attached insertion sheet with the new main PCB to install it.

(1) Remove the SIMM replace lid.

DC fan holder

Screws (yellow)

2 screws

DC fan motor

SIMM replace lid

Figure 4.10

(2) Remove the MIO box.

MIO box

Screws

Figure 4.11

IV - 6