USER’S GUIDE

Checking the Printed Test Pattern or Demo Page

After you print out the test pattern or demo page as described in the previous section, take a look at the printed sheet to check print quality.

The printer has been shipped with the print density properly adjusted with the control panel switches. If you are not satisfied with the printout (too light or dark for example), adjust the print density as follows:

1.Turn on the printer.

2.Press the SEL switch to set the printer off-line state.

3.Press the MODE switch.

4.Press the or switch to scroll through the display until the “ADVANCED MODE” appears.

5.Press the SET switch.

6.Press the or switch to scroll through the display until the “PRINT DENSITY” appears.

7.Press the SET switch.

8.Press the or switch until the desired print density value appears.

The value can change from 1 (light) to 15 (dark).

9.Press the SET switch.

10.Press the SEL switch to exit from the mode menus and set the printer on-line state.

For more information, see “MODE Switch” in Chapter 4.

2–24

Page 262
Image 262
Brother HL-1260 service manual Checking the Printed Test Pattern or Demo