Brother HL-1260 service manual Transfer Unit

1.30Transfer Unit

(1)Loosen a screw.

(2)Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit ( A ) and slide it to the right ( B ) to take off the left part from the main chassis L. Remove the transfer unit from the body by lifting the former.

Screw

Transfer unit

Main chassis L

Right

Figure 4.56

(3)Open the transfer base hook and take off the left bearing (white) from the hook ( A ). Lift the left side ( B ), slide it to the left ( C ) and take off the roller shaft from the right bearing (black) ( D ).

(4)Remove the transfer roller assy.

Caution : Do not touch the sponge rubber roller when replacing the transfer roller (the roller with hand grease or clasped too strongly may result in poor printing quality).

3 Hooks

A

A B

Transfer base assy

D

C

Transfer roller assy

Figure 4.57

IV - 22