Brother HL-1260 service manual Dtrer =ON, Robust Xon =OFF

			CHAPTER 4 CONTROL PANEL
Display Message	Parameters	Settings
BaudRate= 9600	Baud rate	150, 300, 600, 1200, 2400, 4800,
	(Data transfer speed)	9600, 19200, 38400, 57600, 115200
		baud
CodeType=8 bits	Code type	7 bits or 8 bits
	(Data length)
Parity =NONE	Parity	None, even, or odd
	(Data error check)
Stop Bit=1 bits	Stop bits	1 or 2
	(Data separator)
Xon/Xoff=ON	Xon/Xoff	ON:	DTR & Xon/Xoff handshake
	(Handshake protocol)	OFF:	DTR handshake only
DTR(ER) =ON	Data terminal ready	ON:	Makes DTR (ER) low when
(Effective when	(ER)		the buffer is full.
Xon/Xoff=ON)		OFF: Does not make DTR (ER)
			low when the buffer is full.
			DTR(ER) goes low only
			when the printer is off-line.
Robust Xon =OFF	Robust Xon	ON:	Sends Xon while waiting.
(Effective when		OFF: Sends Xon once, when the
Xon/Xoff=ON)			printer status changes from

off-line to on-line.

■Optional Interface

If you have installed a commercial modular input/output (MIO) card in the printer, you can select the optional MIO interface in this mode. If the installed MIO card requires any optional interface settings, they appear under this menu. Set them, referring to the manual of the MIO card.

I/F=OPTION

✒Note

This setting appears only when the MIO card has been installed. For installation of the MIO card, see “MODULAR I/O CARD” in Chapter 5 .

4–19