Brother HL-1260 service manual Error Messages

Table 6.2 Error Messages

Error Message	Meaning	Action
31 PRINT OVERRUN	Print overrun	Press the CONTINUE
		switch to start printing the
		next page. Data which
		overran the print area on
		the page cannot be
		printed. Check your page
		protection setting with the
		MODE switch. Setting
		page protection to the
		correct size could solve
		this problem. If printing at
		600 dpi, you may need to
		add optional SIMM
		memory.
32 BUFFER ERROR	Input buffer overflow	Press the CONTINUE
		switch to resume printing.
		Data lost in overflow
		cannot be printed.
34 MEMORY FULL	Work memory overflow	Press the CONTINUE
		switch to resume printing.
		If the same error should
		occur after you press the
		CONTINUE switch, turn
		off the printer. Wait a few
		seconds, then turn it on
		again . Reduce the input
		buffer size. Turn off
		”KEEP PCL.” Add SIMM
		memory with power off.
		Download font and the
		font saved in the HDD
		card might cause the
		error, for it occupies the
		same work area as the
		RAM. Memory expansion
		is recommended in that
		case.
40 LINE ERROR	Error in the	When the serial interface
	communications circuit	is used, check the
		communications
		parameters such as baud
		rate, code type, parity,
		and handshake
		protocols. When the
		parallel interface is used,
		check the interface cable
		connection.
41 PRINT CHECK	Error in communication	Turn off the printer. Wait
	with the engine controller	a few seconds, then turn
		it on again. See M-17.

VI - 10