Brother HL-1260 Mode Switch Settings in HP-GL Mode, Graphics Mode PEN Setting SETTING=PEN1

CHAPTER 4 CONTROL PANEL

MODE Switch Settings in HP-GL Mode

The following table shows all the selections you can make with the MODE switch in the HP-GL mode.

✒Note

The mode menus and settings that can appear vary according to the current emulation mode, printer status, and any options that may be installed in the printer.

Mode Menu	Setting Menu	Sub-Setting Menu				Setting
INTERFACE MODE
Same as LaserJet 4+ Mode
(See 4-17.)
FORMAT MODE	PAGE FORMAT MODE		PAPER=LETTER			LETTER, LEGAL, A4, A5,
(See 4-20.)			(For 110/120V mode)			A6, B5, B6, EXECUTIVE,
						COM10, MONARCH, C5,
						and DL
			X OFFSET= 0			-500 (left) to +500 (right) dots
			Y OFFSET= 0			-500 (up) to +500 (down)
						dots
			exit			Exit to PAGE FORMAT
						MODE
	GRAPHICS MODE		PEN SETTING
					SETTING=PEN1	PEN1 to 6
						(Set size and gray
						percentage for the selected
						pen. )
					SIZE #=3 dots	1 to 10 dots (pen size in
						dots)
						(# is the selected pen
						number. )
					GRAY #=100%	15, 30, 45, 75, 90, or 100%
						(# is the selected pen
						number. )
					exit	Exit to SETTING=PEN1–6
			exit			Exit to GRAPHICS MODE
			CHARACTER SET
				STANDARD SET		Standard character set
					ANSI ASCII	See character sets on page
						4-28.
				ALTERNATE SET		Alternate character set
					ANSI ASCII	See character sets on page
						4-28.
				exit		Exit to GRAPHICS MODE
	exit					Exit to FORMAT MODE
RESOLUTION MODE	RESOLUTION		RESOLUTION=600			300 or 600 dpi
(See 4-28.)	HRC SETTING		HRC=MEDIUM			OFF, LIGHT, MEDIUM, or
						DARK
	exit					Exit to RESOLUTION MODE

4–13