Brother HL-1260 service manual Self Test, LJ Ready 001P T1, Pressing the Power Switch

USER’S GUIDE

Pressing the POWER Switch

The POWER switch is on the front right hand side of the printer. Pressing the ON side “ ” supplies power to the printe r, which then performs a self test and warm up. Pressing the OFF side “O” turns the power o ff.

ON

OFF

Fig. 2-23 Pressing the POWER Switch

!Caution

Always wait at least 2 seconds after turning off the power before turning it back on.

Do not turn the power off while the printer is printing, as this may cause a paper jam and adversely affect the printer.

The printer performs a self-diagnosis at start-up to check its hardware and software. If the printer should find any problems, the display will show the corresponding message. See “TROUBLESHOOTING” in Chapter 7 .

04 SELF TEST

The display shows several messages quickly at start-up. If the printer detects no errors, it automatically goes on-line and the message changes to show the current printer status and settings.

LJ READY 001P T1

LJ : The auto emulation selection is set and currently the HP LaserJet 4+ emulation mode is selected.

READY : The printer is ready to print.

001 : The number of copies to print is set to 1.

P : Portrait print is selected.

T1 : Paper is fed from Tray1.

2–20