Brother HL-1260 service manual Latch

1.28Latch

(1)Remove the latch from the paper feed guide upper by releasing the 2 hooks.

Paper feed guide upper

Latch

Hook

Hook

Figure 4.46

1.29 Fixing unit (for both 120V and 230V, the only difference is the halogen heater)

(The fixing unit can be disassembled even after removing the rear cover in section 1.6).

(1)Release the hook of the heater lead wire connector (2P) by pinching the connector and pull it out upward (to remove it from the low-voltage power supply assy).

(2)Pull out the fixing PCB connector (4P) to the rear ( A ).

(3)Loosen the 2 screws which are securing from the rear, and remove the fixing unit by pulling it to the rear.

Heater lead wire

Connector (2P)

A

Connector (4P)

Screw	Screw
	Fixing unit

Figure 4.47

IV - 19