Brother HL-1260 service manual Interface Mode

CHAPTER 4 CONTROL PANEL

6. Press the ▲ or ▼ switch until the exit menu appears on the display.

exit MODE

7.Press the SET switch.

Then the printer automatically returns to the off-line ready state.

INTERFACE MODE

The automatic interface selection has been factory set. If you want to select a specific interface manually, use the interface mode to set it.

Display Message	Interface Mode
I/F=PARALLEL	Parallel interface
I/F=RS-232C	Serial interface
I/F=OPTION	Optional interface for MIO card
I/F=AUTO	Auto interface selection

Select the setting menu and enter the sub-setting menu to change the setting as follows:

■Automatic Interface Selection

When you use the automatic interface selection function, select the function on the display as follows:

I/F=AUTO

When you select this function with the SET switch, the display shows the next sub-setting menu as follows:

TIME OUT= 5s *

You need to set the time out for the auto interface selection from 1 to 99 seconds with the ▲ or ▼ switch: factory setting = 5 seconds. This time out is the duration during which the printer will not allow another automatic change to the interface.

4–17