Brother HL-1260 service manual Loosen a screw and remove the fixing PCB assy

(4)Take off the halogen heater from the heater support spring, remove the halogen heater by pushing it and pulling the heater support spring at the same time ( A ).

Fixing unit

Heater support spring

A

A Support spring Pull

A A

C

Heater Push

Halogen heater B

Halogen heater

Figure 4.48 Figure 4.49

(5)Loosen 4 screws and remove the thermistor lead wire connector (2P) of the fixing PCB (see Figure 4.51), and remove the fixing unit cover by detaching the wire from the hooks of the fixing unit chassis.

Screws

Screws

Fixing unit cover

Hooks

Fixing unit chassis

Figure 4.50

(6) Loosen a screw and remove the fixing PCB assy.

Connector

Fixing PCB assy

Screw

Figure 4.51

IV -