Connecting the Switch | Milan Technology MIL-S1000 guide

Connecting the Switch

You can connect your switch to network devices such as desktops and workgroups or to other hubs.

Before connecting your switch to a desktop or workgroup make sure that:

#The 10Base-T twisted pair Ethernet cabling is Category 3 or above.

#The 100Base-TX Fast Ethernet cabling is tested Category 5.

#The 100Base-FX fiber cabling is 62.5/125 micron multi- mode fiber.

#The 1000Base-SX/LX fiber cabling is 50/125, 62.5/125 micron multi-mode or 9/125 micron single-mode fiber.

Image 34

Milan Technology MIL-S1000 user manual Connecting the Switch

Contents

MIL-S1000  Copyright Table of Contents Introduction Planning your Network Installation Module Install and Removed Introduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear Panels Red Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX Module DIP Switch with Link Mode Dip switch location and mode settings 8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front View Ports 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber Module Enable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines 100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines 1000BASE-SX and LX Network Guideline Network Planning Expanded Networks 10Base-T Networks 100Base-TX Networks Expanding your 100Base-TX network Class Collapsed Backbone Link 100Base Solution Fileserver Link Fileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth Backbone Used as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the Modules Module Setup and Installation Insert the module Installing 10/100Base-TX Modules Installing the ModulesInstalling 100Base-FX Modules Installing 1000Base-SX/LX Modules Removing the Modules Physical Characteristics Compatibility with Ethernet Standards Address Table Switching ArchitectureLED Indicators Forwarding Rate Appendix B. Pin Assignments Switch Adapter Hub