Milan Technology MIL-S500 manual Product Specification, Power, Cabling, General Specification

The Switch can be easily monitored through panel indicators that assist in the identification of problems. This section describes common problems you may encounter and where you can find possible solutions.

Power

If the power indicator does not turn on when the power cord is plugged in, you may have a problem with the power outlet, or power cord. However, if it powers off after running for a while, check for loose power connections, power losses or surges at the power outlet. Or, you may try to unplug the power cord on the Switch, wait for five seconds and then reconnect. If you still cannot resolve the problem, call our technical support hotline.

Cabling

Verify that the cabling type is correct. Be sure all cable connectors are securely seated in the required ports. Use all standard unshielded twisted-pair (UTP), Category 3, 4, or 5 cables or Category 5 only when connecting with Fast Ethernet. Make sure the maximum distance between the Switch to the workstation, or Switch is 100 meters.

Product Specification

General Specification

Standard Compliance

Number of Ports

Data Transfer Rate

Network Cables

Topology

LED Indicators

Per Device

Per Port

IEEE 802.3 10Base-T Ethernet

IEEE 802.3u & 802.3x 100Base-TX Fast Ethernet

5X 10/100Mbps Auto-sensing RJ-45 ports

Ethernet: 10Mbps(half duplex) 20Mbps(full duplex)

Fast Ethernet: 100Mbps(half duplex) 200Mbps(full duplex)

Unshielded twisted-pair cable

Star

Power

100Mbps, LINK/ACT

9