Milan Technology MIL-S801XX user manual Rear Panel, Desktop Installation

Rear Panel

The 3-pronged power plug is located at the Rear Panel of the 9-Port switch as shown in Figure 2-6. The switch will work with AC in the range 100-240V AC, 50-60Hz.

Figure 2-6 The Rear Panel of the MIL-S801XX switch

Desktop Installation

Set the switch on a sufficiently large flat space with a power outlet nearby. The surface where you put your switch should be clean, smooth, level, and sturdy.

Make sure there is enough clearance around the switch to allow attachment of cables, power cord and air circulation.

Attaching Rubber Feet

A.Make sure mounting surface on the bottom of the switch is grease and dust free.

B.Remove adhesive backing from your Rubber Feet.

C.Apply the Rubber Feet to each corner on the bottom of the switch. These footpads can prevent the switch from shock/vibration.

Figure 2-3. Attaching Rubber Feet to each corner on the bottom of the switch

Power On

Connect the power cord to the power socket on the rear panel of the switch. The other side of power cord connect to the power outlet. The internal power supply in the switch works with AC in the voltage range 100-240VAC, frequency 50~60Hz. Check the power indicator on the front panel to see if power is properly supplied.