Miller Electric 293 Installing Drive Rolls and Wire Guide, Aligning Drive Rolls and Wire Guide

3-9. Installing Drive Rolls and Wire Guide

	1	Securing Screw
	2	Inlet Wire Guide
	Loosen screw. Slide tip as close to
	drive rolls as possible without
	touching. Tighten screw.
5	3	Anti-Wear Guide
3	Install guide as shown.
	4	Drive Roll
2	The drive roll consists of two differ-
	ent sized grooves. The stamped
	markings on the end surface of the
	drive roll refers to the groove on the
	opposite side of the drive roll. The
	groove closest to the motor shaft is
	the proper groove to thread.
	5	Drive Roll Securing Nut.
1	Turn nut one click to secure drive
	roll.
4

Tools Needed:

5/64 in 7/16 in

3-10. Aligning Drive Rolls and Wire Guide

			Y Turn Off power.
			View is from top of drive rolls
			looking down with pressure
			assembly open.
	Correct	Incorrect	1	Drive Roll Securing Nut
3	4		2	Drive Roll
2			3	Wire Guide
1			4	Welding Wire
			5	Drive Gear
	5		Insert screwdriver, and turn screw
			in or out until drive roll groove lines
			up with wire guide.
			Close pressure roll assembly.

Tools Needed:

Ref. 800 412-A

OM-223 194 Page 13